SUPPORT EQUIPMENT AND SUPPLIESConsumables/SoftwareCat. Do not reusesdamaged shipping containers.CAUTION: Originator assumes all liabilityfor damages incurred to equipment duringshipment to Gendex for warranty or nonwarrantyrepairs.2.7. Make sure allcomponents are securely fastened to the cartprior to moving.For prolonged periods of non-use, it isrecommended the system and its accessories arecovered and kept at room temperature in a drydust-free environment.Shipment of the system or any of its componentsand accessories should be done so using theiroriginal shipping containers. Do not attempt to tilt, liftor manipulate a cart over thresholds, cables,or other obstructions. To reduce the risk ofpersonal injury and property damage, alwaysmove a cart based system slowly and in acontrolled manner. MOVING, STORAGE, AND SHIPPINGWARNING: Cart based systems present atipping hazard. The primary video source is the AcuCamHanpiece (Green LED, right side of the button) the alternative video source is whatever isconnected to the Video-IN input available on theDocking Station Back Panel (Amber LED, leftside of the button).Concept IVHandpieceConnectorVideo 2 LED - Amber(Alternative Source)Lamp On/Off Switch&Video Source ToggleVideo 1 LED – Green(Concept IV Camera)Front PanelHolsterLight SensorAcuCam ® Concept IV FWT Docking Station and HolsterHolsterMeaning of the LEDGREEN BLINKINGGREEN ONAMBER ONAMBER BLINKINGBOTH BLINKINGBOTH ONThe system is powered and in Standby mode.The AcuCam Hanpiece is streaming video.The system is powered and the alternative video source is selected.The system is running the equipment diagnostic.It happens for a few moments only, when powering up the system by pluggingin the power connector.Faulty condition (the camera is in programming mode, used during theproduction phase only).AcuCam Concept IV FWT 10 Operation Manual and Installation GuideĢ.6.

Two LEDs indicate the selected videosource. The Holster can beattached to the Docking Station, to the left or tothe right, or it can be mounted beside a cabinet,connected to the dental chair delivery unit oranywhere nearby the patient area.A button on the Holster allows to switch On andOff the Handpiece light source or, holding thebutton for two seconds, to select the videosource. Two cables, ofdifferent length, are supplied. It can be relocated near by theDocking Station or far from it, through theappropriate connecting cable. The Concept IV FWT Holster -The Holster accommodates the Handpiece whilenot in use.

Acucam Concept Iv Drivers